Svs Ultra Speakers User Manual download pdf (Page 11)

SETTING UP YOUR ULTRA SURROUND

SURROUND MODES (cont’d)

Bipole Mode

Bipole mode is the factory default conﬁguration. For bipole conﬁguration, perform the

following steps:

• Attach the jumper straps as shown in the below diagram.

• Connect the ampliﬁer wires to the lower (Duet 2) binding posts.

Dipole Mode

For dipole conﬁguration, perform the following steps:

• Remove the jumper straps (failure to do so could damage the ampliﬁer).

• Install the dipole wiring kit as shown in the below diagram.

• For the right surround channel, connect the ampliﬁer wires to the lower (Duet 2) binding posts.

• For the left surround channel, connect the ampliﬁer wires to the upper (Duet 1) binding posts.

Straps must be

attached

DIPOLE CABLE KIT

RIGHT Surround

(connect to lower binding posts)

Remove

Straps

LEFT Surround

(connect to upper binding posts)

Remove

Straps

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

No comments

Svs Ultra Speakers User Manual Page 11