SVS 7 LIFTINSTALLATION INSTRUCTIONS(110V)SVS, INC. Lifting Your Image2513 Jenks AvePanama City, FL 32405www.svslifts.comTel: 850-522-4747Fax:850-
Remove the blocks by removing the screws and tie-raps holding them in place.TO AVOID CABLE SPILLS• Do not push the lift bottom frame upwards once the
the toggle switch stops the Lift. This is designed as a safety feature. The key switch is an extra precaution, when the key is removed, the Lift is se
9. ACCESSORY INSTALLATIONPlease refer to the accessory installation instructions located in the accessory shipping crates for specific
11. CABLE MANAGEMENTCable Management is used to keep projectors cables away from the scissors during Lift operation. Do not attach the projector cable
b. Accessory #7 Cable RetractorAccessory #7 Cable Retractor is standard equipment on SVS 7-15, SVS 7-18, SVS 7-20, AND SVS 7-22. See Figure 11. The C
7. Make one and a half turns around the cable reel counter clockwise with your cable. Lock your cable in the same way as in Step 6, to the two remaini
Drum Lock arm. If the drum rotates too fast, the pawl will swing out and catch the arm, locking the drum after the first rotation.• The Cable Drum Bea
14. TROUBLESHOOTINGAll SVS Lifts are quality checked before they leave the SVS Factory and are fully operational. Shipping damage and installation ove
Lift works with the key switch in the Service position but will not lower in the Show positionThe Show position microswitch may be set too near the re
SVS 7 LIFTINSTALLATION INSTRUCTIONSSECTIONS: Page 1. General Description...
SVS 7 LIFT1. General Description:The SVS 7 Series Lift is designed to support projectors up to 26-inches wide (66cm) and features lowering distances f
3. SVS 7 LIFT WARRANTYSVS, Inc. 's limited warranty only covers failures due to defects in materials or workmanship that occur during normal use.
IMPORTANT: PLEASE READ THROUGH ALL INSTRUCTIONSBEFORE BEGINNING YOUR INSTALLATION.This Lift is designed to be used with a Wall Plate Controller, eithe
and other objects away from the scissors and other moving parts. Technical personnel should always be present whenever the Lift is in the Service mode
6. LIFT SUPPORTING STRUCTUREThe SVS 7 Lift should be mounted from four 1/2” rods. The mounting hole locations are marked with a <M> in Figure 4.
If the ceiling clearance allows, an “X-Y” or a cross-supporting structure is strongly suggested as shown in Figure 6 Recommended Lift Support Structur
ImportantWhen attaching the Lift to a flat concrete ceiling, SVS suggest two (2) pieces of P1000T Unistrut (or equiv
Comments to this Manuals